The LED will be illuminated if the UPS is plugged into an improperly wired utility power For ordering details contact your dealer orĪPC through the Web site 120 V models only: The UPS is equipped with a Site Wiring Fault LED located on the rear panel of Where appropriate use an APC extension battery cable. The UPS is equipped with an external battery connector located on the rear panel of the unit. The UPS features a TVSS screw located on the rear panel for connecting the ground leads on Install the UPS at or near the bottom of the rack. Install the UPS in the Rack and Connect the Battery Module This UPS is intended for installation in a 19” rack.įor details on rail installation refer to the instructions in the rail kit.
Remove the battery modules to lighten the UPS during installation. The UPS and the battery modules are heavy. Your UPS model may vary in appearance from the examples depicted in this manual. Maximum Number of External Battery Packs Supported by the 15° to 30☌ (5° to 86☏) charge the UPS battery every sixģ0° to 45☌ (86° to 113☏) charge the UPS battery every threeĠ to 95% relative humidity, non-condensing For some models, an additional label is located on the chassis under the front bezel. NOTE: The model and serial numbers are located on a small, rear panel label. The packaging is recyclable save it for reuse or dispose of it properly. Notify the carrier and dealer if there is damage. Read the Safety Guide before installing the UPS. Install accessories prior to connecting power to the UPS.
If a standard accessory, such as a Network Management Card is installed on this UPS, refer to the accessory user manual or CD for installation and operation instructions. Refer to the APC Web site, for available accessories. This UPS is equipped with an accessory SmartSlot.
The UPS provides continuous power from the batteries until utility power returns to safe levels or the batteries are fully discharged.
The UPS filters small utility line fluctuations and isolates electronic equipment from large disturbances by internally disconnecting from utility line power. The APC Uninterruptible Power Supply (UPS) provides protection for electronic equipment from utility power blackouts, brownouts, sags and surges.
0 kommentar(er)
